Remote Access Guide

Machines running Groovix PAC software can be remotely accessed in two ways, through SSH or VNC. An SSH client emulates the Linux xterm command line interface while a VNC client mirrors the workstation desktop GUI.

SSH (Secure Shell)

SSH is a network protocol used to pass commands and data securely between two workstations. For SSH administration using two Linux machines, only an xterm window is necessary. For SSH administration in a Windows environment to a Groovix machine, an SSH client program is needed; one suggestion is PuTTY, a free, open-source SSH client.

Starting an SSH session

To start an SSH connection, open an xterm window and type the command ssh [username]@[IP], you will be prompted for the password of the [username] used before gaining control of the workstation.

To start an SSH session in Windows, launch the SSH client on a local machine, enter the IP address of the workstation and click “Open” to be provided with a terminal window similar to xterm in Linux.

[image]

Ending an SSH session

To end an SSH session, type exit and press [ENTER].

Using SSH with multiple workstations

When performing work on multiple systems that will all use SSH, it is not necessary to close an existing SSH session and start another for the next workstation. To SSH into another workstation, type ssh [username]@[IP]. If the authenticity cannot be verified, there will be a prompt asking to continue, type yes. Once verified, the [username] password is necessary to gain access to the workstation. When one session becomes multiple workstations deep, typing the exit command will back up one workstation at a time until the original workstation is reached; only at this time will the exit command close the SSH connect and xterm window.

Sending commands along with an SSH connection

Adding a '|' plus a command after the SSH command will execute the command once the SSH session has been authenticated with the [username] password (ex. ssh root@192.168.0.1 | shutdown -h now).

VNC Remote Connection

When using VNC, it is important to remember that you are taking direct control of the workstation, your display and actions will be shown if the machine you are controlling has its local monitor powered on; keep this in mind before displaying sensitive information/passwords/etc. to the public.

There are two ways to start a VNC session, through a web browser or a VNC client.

VNC using a web browser

Point your web browser to the workstation’s IP address you want to connect to, a colon and the port number 5820 (ex. 192.168.0.1:5820). The browser will display the VNC Authentication page and requires a password before remote controlling can begin.

[image]

Click the “OK” button to open a window of the workstation’s display (shown below).

[image]

== Using VNC client software: Launch the VNC client software on a local machine and enter in the IP address of the workstation you want to connect to.

The client will display the VNC Authentication page and requires a password before remote controlling can begin. Click on the “OK” button and you will be presented with a window of the workstation’s display.

For VNC administration in a Windows environment to a Groovix machine, a VNC client or web browser is needed; one suggestion is RealVNC a free, open-source VNC client.

Note: When using VNC, if the workstation is not logged in, logging in closes the current interface while it loads the desktop thereby closing your VNC window in the process; repeat the same steps to reconnect and resume the VNC session. Some VNC clients have the option to automatically reconnect upon a dropped connection, in these instances, click the “OK” button to resume the session when prompted.